Water-Proofing Bathrooms
The Bath Room leakage means that the water leaks into the area below the Bath Room and is seen from below area on Roof/walls etc.
The cause of leakage can be due to:
1) Water Supply line into the Bath Room might have got damaged causing the leakage.
2) The tile joints or the waste water pipes coming from Wash Basin, Closet, and Floor trap could be the cause of leakage
Tips to Test:
Whether the leakage is from Water Pipe Lines or waste water line is simple.
1)Please check if the leakage continuous even if the Bath Room is not in use, then it is definitely from water pipe lines and our Aquatyte treatment is not proposed.
2) If there is water dripping /wetness /Paint peeling off due to moisture in below Roof
and the dripping comes down occasionally, when the bath room is not in use, then
the leakage is from the waste water pipe lines, and Aquatyte treatment strongly
recommended to give result
Treatment:
The Bath Room leakage of waste water line can be due to the floor joint cracks or the connecting discharge pipes from Wash Basin, Floor trap or Closet may be leaking. In modern practice all the Bath Room pipes are concealed, run below the Floor of the Bath Room between the Floor and sunken slab. Hence if the pipe line has to be treated, it may be necessary to break open the Floor to access the joints.
Each Box of Special AQUATYTE SPECIAL Bath Room Leakage Arresting Kit is designed to consume all the 5 Kgs.per Bath Room consisting of One No. Closet, One Wash basin, one-two Nos of floor traps, and 15 to 40 Sft.of Bath Room floor.
PRINCIPLE OF TREATMENT:
In Aquatyte treatment we don’t use Chisel or Hammer, i.e., ‘No Breaking and Alteration’. Hence to treat the leakage we do not propose to break the floor or do any alteration. We can do the treatment in “As is Condition”.
The treatment for Bath Room would take about 30-45 minutes.
The Bath Room should not be used for 24 hours i.e. no water should be poured in the pipe line for 24 hours.
After studying the above facts the Bath Room treated can be taken up Safely with 100% guarantee.
The product Aquatyte is a DIY Kit i.e. Do It Yourself .So any one without any skill can use our product and solve leakage problems at their end.
Treatment:
1) Enter the Bath Room and pour 1 bucket of water into Wash basin,
Closet, Floor traps, Floor, Bathtub etc.
2) Mix 5 Kgs. Aquatyte into 20 ltrs.of water in a bucket pour about 7ltrs.into closet.
2-3 ltrs.into Wash Basin.
2-3 ltrs.into floor trap and rest on floor.
3) Wipe the solution with dry cloth or sponge; remove the solution remaining in the water
seal of floor trap, Wash Basin, Closet etc. completely .If any solution is left in the
water seal, it may cause blockage next day. Please take care.
4) Do not use the Bath Room for 24 hours.
Be assured from the time of treatment there is no fresh leakage happening in the area.
You may be able to observe the wet patches or dripping coming down gradually in 2-7 days.
What have we done?
While Aquatyte solution passing through the pipe line (PVC, Plastic, G.I, M.S, C.I) it seals all the joints, defects, cracks in the pipe line automatically.
No guidance is required.
1) Do not use more/less materials to do this treatment. Use only recommended dosage of solution.
2) Clean the water seal properly.
3) Each Bath Room requires 5 Kg.material.